Gravel Calculator

Calculate cubic yards, tons and bags of gravel for a path, driveway or drainage bed.

Your numbers
Your project

Gravel Needed

Enter your numbers above.

Not sure which mulch, rock or soil fits your project? Take the Material Finder.

Take the quiz

How it works

Gravel is usually sold by the ton from a quarry or yard, but the depth you need is measured in inches. This calculator bridges the two: it converts your area and depth to cubic yards, adds an allowance for compaction, then converts to tons using a density. Crushed stone commonly runs 2,700 to 3,000 pounds per cubic yard, so 1.35 to 1.5 tons per yard is typical; the calculator uses 2,700 pounds per cubic yard.

Typical depths vary by job. Walkways and garden paths often take 2 to 3 inches. Driveways commonly use 3 to 4 inches of crusher run as a base, topped with about 2 inches of a clean stone such as #57. Always ask your supplier for their actual weight per cubic yard, since it differs between stone types and quarries.

A 50 pound bag of all-purpose gravel holds about 0.5 cubic feet, so it takes about 54 bags to make a cubic yard. Bags make sense for small patches; bulk is much cheaper per ton for anything bigger.

Where these numbers come from

The formulas and default values in this calculator are based on:

These are planning estimates. Local conditions, product labels and your supplier or extension office come first.

Frequently asked questions

How deep should gravel be for a driveway?

Most residential driveways use about 3 to 4 inches of crusher run as a base with a 2 inch top layer of #57 stone. Soft soil or heavy vehicles call for more base. A local supplier can recommend depths for your soil.

How many tons of gravel in a cubic yard?

About 1.35 to 1.5 tons for most crushed stone. For example, #57 stone is roughly 1.4 tons per cubic yard. Check with your supplier because rock type and moisture change the weight.

Should I add extra for compaction?

Yes. Loose gravel compresses once it is driven on or tamped, so a 10 percent allowance is a common starting point. The calculator includes this in the waste field.

All LawnCalcs tools